Bearings for G-Laders
The bearing is an essential part of your G-Lader since it is responsible for power distribution and rotation. At the same time, the G-Lader bearings are vulnerable wear parts that ought to be checked for functionality at regular intervals. The following must be borne in mind: An overhaul of the G-Lader is far cheaper than a repair in the event of damage. This is why you should always have an eye on the G-Lader. You get all the bearings relevant for your G-Lader here.
- Bearing for beside-shaft
- Bearing kits
- Needle bearing
- Main bearing
Many tuning fans tend to avoid replacing all bearings, if only for reasons of cost. In addition, you need special tools for it. If you have us do the overhaul, you’ll benefit from our twelve-month warranty, since we measure all the parts of the G-Lader precisely and clean them. In so doing, all five bearings are also replaced. This is the only way to prolong considerably the service life of your G-Lader!
Ready to ship immediately!
Ready to ship immediately!
Ready to ship immediately!
Ready to ship immediately!
Ready to ship immediately!
Ready to ship immediately!
Ready to ship immediately!
Can be delivered in 5 to 8 days
Extra Performance With a Working G-Lader
The G-Lader ensures that the pressure in the inlet pipe is increased and correspondingly more fuel-air mixture is processed. This increases the average working pressure, enhancing the performance of the engine considerably. This is why, in tuning, the G-Lader is a good starting point for optimization. For the G-Lader to work smoothly and for you to be able to use the entire performance potential, all parts, and especially the bearings of the G-Lader, must be serviced regularly.
Why Would You Want to Replace All the Bearings?
All G-Lader bearings are exposed to a certain amount of wear, some more, some less. Nonetheless, you should replace all five bearings during an overhaul. This is the only way to guarantee a long service life of your G-Lader. The needle bearing for the displacer, for example,wears down very fast, since it must withstand the eccentric movements of the displacer. If you want to be on the safe side and implement a proper overhaul, you should fall back on a complete bearings kit. We have kits by FAG for the G60, for example.